
claman
Enthusiast
Hi Bill.
Center is hocked on a different relay comparted to Surround L+R, and coming form the same IC amplifier. Since Center works, than the amplifier must be ok. Also from previous post, since L is working and R with issues, I can say Main amplifier is working well. So I suspect either shorts, offset capacitor values, caps that might leek and currently shorting something, bad solder joints for those ICs(51 and 52). There are numerous causes.
1. How old is this amp?
2. how often it is being used
3. you had it for new? or it's bought SH?
You could open it yourself and do a visual inspection on all the components for: bulged capacitors, signs of leakage capacitors, burnt resistors, burned signs, anything unusual, and post some quality pictures on a Webdrive(like Google drive) where I can download it.
At least if you can measure the voltage (in mV - milli-volts) from the OUTPUT terminals would give some clues about it.
I assume the repair would be fairly cheap, and if only some resistors or capacitors, or maybe relays needs to be replaced, probably this will be taking up some money depending on quality but not too much. Relays for example can be serviced.
Regards,
Claudiu
Center is hocked on a different relay comparted to Surround L+R, and coming form the same IC amplifier. Since Center works, than the amplifier must be ok. Also from previous post, since L is working and R with issues, I can say Main amplifier is working well. So I suspect either shorts, offset capacitor values, caps that might leek and currently shorting something, bad solder joints for those ICs(51 and 52). There are numerous causes.
1. How old is this amp?
2. how often it is being used
3. you had it for new? or it's bought SH?
You could open it yourself and do a visual inspection on all the components for: bulged capacitors, signs of leakage capacitors, burnt resistors, burned signs, anything unusual, and post some quality pictures on a Webdrive(like Google drive) where I can download it.
At least if you can measure the voltage (in mV - milli-volts) from the OUTPUT terminals would give some clues about it.
I assume the repair would be fairly cheap, and if only some resistors or capacitors, or maybe relays needs to be replaced, probably this will be taking up some money depending on quality but not too much. Relays for example can be serviced.
Regards,
Claudiu