A

andyblackcat

Audioholic General
First of a few quad 4 channel slim Behringer EPQ304 4-channel

b2.jpg


1.jpg


Once the 37-D connector arrives I can see if the mating with Dolby CP500 can be used with logarithmic potentiometer works correctly or not if not I'll keep a look out.

2.jpg


New PSU mounted inside the rack and all mains cables will be tied up and kept to one side of the rack away from audio leads to prevent possible 50Hz mains hum being picked up.

A lot of the cables behind soon to be all tided up.

b1.jpg


3.jpg


4.jpg


Amps tested but no TRS 1/4" connected yet nor any Sparkon twist cables. The fans are sort of quiet bit produce a certain frequency that is the upper middle Hz to lower Khz range. I'll have to test once they are up and running with TrueRTA to see what the fan noise frequency is?

5.jpg


The quad 4 channel amplifiers will be used for the JBL five screen HF horns and I may use more for the each sidewall/rear wall surrounds and overhead surrounds and use slightly powerful ones for the five screen bass channels.
 
A

andyblackcat

Audioholic General
A third Behringer EPQ304 arrived this morning with Sparkon push and twist connectors and packets of TRS to RCA so I can use the existing RCA cables.

1.jpg


2.jpg
 
A

andyblackcat

Audioholic General
Once all Behringer EPQ304 was in place for the 5 screen HF horns and with all amplifiers running the noise from the fans was bit distracting. I had a look around before opening up. What I found was the tiny fans tend to be bit noisy. These amplifiers maybe for PA use but the fan noise is unacceptable in frequency noise.

The way I see it with most AVR's of the past that hardly used fans inside them and with other amplifiers or pro gear that doesn't use fans. I simply disconnected the fans (the leaf blowers) for silent operation and I doubt they are going to get Red Hot even within few hours. I pre-tested with one switched ON for 10 minute and was reasonable cool.

I have left a small narrow gap between the amplifiers so any raising heat is going to vent though the narrow slots around each amplifier.

3.jpg


4.jpg
 
A

andyblackcat

Audioholic General
Two of them presently connected up for JBL 2371 HF horns for the five-screen channels.

I'll do a check with the 3rd for surrounds to see how it sounds before getting a 4th EPQ304.

The EPQ304 are rated at 75watts that may seem like not a lot but the JBL 2371 are high sensitivity 109db, for a 1watt to reach 109db at 1 meter distance, rated at 50watts and at short distance away in the room I doubt they'd ever see more than 2watts peak nor have they ever when using the other AVR running as an amplifier.

The gain levels are set rather low just two notch turns on the gain levels.

5.jpg

6.jpg
 
A

andyblackcat

Audioholic General
Captain Kirk, just beamed in though the afternoon mail.
48417065_10156722689440149_4976011988019707904_n.jpg

48423356_10156722689685149_4232718475258232832_n.jpg

48430228_10156722689070149_2719406617031344128_n.jpg

"we're looking for some kind of creature that feeds" :D
 
A

andyblackcat

Audioholic General
Moved the "Shat" standing behind the back row seats wearing an xmas hat.
s.jpg
 
A

andyblackcat

Audioholic General
Moved the Alesis RA300 amplifiers into the other rack. I don't like class A/B amplifiers they weigh to heavy.

Going need few more PSU.
1.jpg
2.jpg
3.jpg
 
A

andyblackcat

Audioholic General
Another Laserdisc player arrived today.

1.jpg

2.jpg

Sooty, black cat approves of Laserdisc.

Second Pioneer DVL-909 that I already have expect this model is for region 3 for its DVD use but can be programmed with the remote control for other DVD regions.

The back panel layout is different that doesn't use SCART just multiples of Video outputs and RCA LR outputs plus the regular digital coaxial, Dolby AC-3 RF output and PCM optical digital output.

4.jpg

5.jpg


I only tested with video lead connected to back of monitor as I haven't got any rack space left in the main two racks. A few Laserdiscs the owner also supplied with it some that I already have others that I don't have.

3.jpg


Ghostbusters (1984) criterion collection looked okay.

The main video player rack I'll move all the players into the kitchen with some new longer HDMI leads for the 4k, bluray, HD-DVD and regular leads for the other players Laserdisc and VHS. I'll use an (IR emitter) so the players functions can be controlled in the THX home cinema.
Rack tray will have to be installed for Laserdisc players VHS at 4U frame size and for the smaller players 4K, bluray, HD-DVD 2U frame size.
 
A

andyblackcat

Audioholic General
JBL 4312 in fair cosmetic condition few minor repairs but in working order, delivered yesterday.

Seller was very nice to travel down from London, (twice) within 48hrs good seller that wants his costumer to listen to the speakers. I didn't include in the pictures JBL 4312A.

48415617_10156732189580149_208439152331456512_n (1).jpg

JBL 4312 left channel stood on a JBL control SB-2 to raise it off the floor.

48418908_10156732189715149_7808011292974776320_n.jpg

JBL 4312 right channel

49310580_10156732277780149_6397770734227161088_n.jpg


48961969_10156732277880149_926003487412584448_n.jpg


Not the best pictures I took I was rather cranky and wanted to go to bed so maybe take some more pictures later on when not so cranky.

48415731_10156732298220149_2932351430574473216_n.jpg

I couldn't get the JBL 4312 connected up to test with any of main system so rigged up quickly a one of 2x Marantz 1050 connected long phone 3.5mm to pc computer output with RCA connected to amplifier and used some youtube videos for music and frequency sine wave sweep 20Hz to 20Khz to test each of the two JBL 4312 and JBL 4312A that the seller had for me to listen too to see which one I would like to buy.

The JBL 4312A had a nice bass that I noticed on the frequency sweep and all though the range to middle and high on the titanium diamond tweeter. The only differences no L-Pads for mid/highs and the port wasn't as unique like JBL 4312 that has 45 degree bend that extends longer into the box.

The tweeter on JBL 4312 is paper dome tweeter I can live with that they work.

I may think about using the 3rd Behringer DCX2496 DSP crossover for the JBL 4312 with an extra output on the main rack system with sort of, (A) multi ch home cinema and (B) 2ch stereo speakers, maybe...?

I am at the point now I have to quit buying JBL or anymore speakers OCD as gotten out of control. :D Unless spare parts. One more box soon to arrive from USA, JBL 2206 x5 to replace the JBL G-125 bass mid in the JBL control 12SR.
 
A

andyblackcat

Audioholic General
JBL Control SB-2

Seller was kind enough to travel all way down from London to personally deliver.

These where designed for top corner mounting against three boundary surfaces two wall boundaries and one ceiling boundary that will increase its SPL efficiency.

They all look so new even thou used but look in great cosmetic condition with no chips or dents.

48390062_10156728065710149_5636332393389359104_n.jpg




49064919_10156728066465149_1028834221478641664_n.jpg


48380577_10156728066350149_506285431977934848_n.jpg


48390395_10156728067155149_2494594375057670144_n.jpg


48419943_10156728066810149_6477616650160963584_n.jpg

The metal mesh grill is an issue and will be removed due to when tapping on the enclosure it resonates with a "pinging" sound not a big deal to sort out and fit some damping inside as well.

Figuring out where to fit them as rear back room top corners are taken up with JBL 8330 mkII, so very little options for placement.

48408857_10156728067365149_8787699895902404608_n.jpg
101 uses it has I can place it on its side.

48385990_10156728067540149_5646934305411170304_n.jpg

The port slots into the rest of the speaker box and has foam pads on the sides as the rest of the bass sounds travel out from the driver that is a 10" duel voice coil and the baffle acts like a sort of band-pass filtering, maybe not the best to everyone's taste or hearing but, I think I can work with it.

48414857_10156728069875149_252948276377026560_n.jpg

Magic thought all these JBL's was cat climbing tree.
 
A

andyblackcat

Audioholic General
Gotta mute the THX cinema once in while and play with one my two cats, Magic.

 
A

andyblackcat

Audioholic General
First of x4 JBL 2206 with 5th arriving next week.
Installed for the five screen bass channels . Three installed now and sound nice.

49502979_10156743489795149_6610639874741501952_n.jpg

49132489_10156743480625149_5914965300045938688_n.jpg
 
A

andyblackcat

Audioholic General
William Somerset: [discovering what's inside the package] California, tell your people to stay away. Stay away now, don't - don't come in here. Whatever you hear, stay away! John Doe has the upper hand!

Magic: [curiously sniffing the box] What's inside the box?
1.jpg
 
A

andyblackcat

Audioholic General
5th JBL 2206 arrived today and now I can install the last two new/used bass drivers into the left-centre right-centre.
2.jpg


5.jpg


6.jpg

Between installing the new JBL bass drivers while watching ALIENS.

7.jpg


9.jpg


11.jpg

I say we JBL it from orbit. Its the only way to be sure.
 
A

andyblackcat

Audioholic General
Added new Behringer NX3000 (leaf blowers) but fortunate the amplifier rack is in the kitchen so very litter fan noise is heard and when the door is closed its a nice 30db in the room.

The NX3000 power the JBL five screen bass channels JBL 2206.
50072452_10156780616255149_6320446062880358400_n.jpg
49949937_10156780616525149_7885320983475650560_n.jpg
50304694_10156780616740149_6005901882394935296_n.jpg
49298216_10156780617975149_7091107008467697664_n.jpg
49401457_10156780695245149_6708968555368415232_n.jpg
50018999_10156780695235149_7445311750188040192_n.jpg
 
A

andyblackcat

Audioholic General
William Somerset: [discovering what's inside the package] California, tell your people to stay away. Stay away now, don't - don't come in here. Whatever you hear, stay away! John Doe has the upper hand!

Magic: [curiously sniffing the box] What's inside the box?
1.jpg
2.jpg
3.jpg

Magic likes theatrical original Dolby Stereo Star Trek on laserdisc
 
A

andyblackcat

Audioholic General
x4 mains to transformer LED lighting to be later fitted up. The lumens light level is nice output as I got a bright type.

Fixing screws and wall plugs, lightweight so shouldn't take long to fit up then do the mains wiring from light switch and later on install a variable dimmer control.

1.jpg

2.jpg
4.jpg
 
A

andyblackcat

Audioholic General
Ordered some cable conduct so it can be concealed within the sound treatment tiles. An LED light dimmer and mains lamp cable so should have the lights operational next week.

Drilled small hole enough so mains lamp cable can fit though and will do same with other x3.
1.jpg


One light box panel fitted up and I only need to cut back the sound treatment foam.

2.jpg

3.jpg
 

Latest posts

newsletter

  • RBHsound.com
  • BlueJeansCable.com
  • SVS Sound Subwoofers
  • Experience the Martin Logan Montis
Top