Subwoofer Product and or placement recommendation

[Capt'n_Ron]

Room is 2700 Cu/ft. rectangular shape.
front wall corner subwoofer placement is not an option due to room width and main speaker location.
Usage 70% movies and 30% music.
Budget, want to stay below 1500 delivered.

Considering a mid wall sub possibly a HSU VTF-TN1
or
Front wall placement inside of either the Left or Right main below the FP screen. This would have to be a smaller VTF3 MK5 HP

Appreciated any input. Thanks

 

[Wardog555]

Nobody can say where to place a subwoofer as you need to test and measure each location.
Under no circumstances do you ever go with a smaller subwoofer based on where you want to place it. This doesn't work in your favor for performance reasons.

 

[lovinthehd]

Might even consider multiple subs rather than a single. Positioning in your room would be hard to guess at. Old saying that subs work best where they need to go, not necessarily where you need them to go The Hsu subs you mention are quite good in any case.

 

[shadyJ]

Room is 2700 Cu/ft. rectangular shape.
front wall corner subwoofer placement is not an option due to room width and main speaker location.
Usage 70% movies and 30% music.
Budget, want to stay below 1500 delivered.

Considering a mid wall sub possibly a HSU VTF-TN1
or
Front wall placement inside of either the Left or Right main below the FP screen. This would have to be a smaller VTF3 MK5 HP

Appreciated any input. Thanks

I would look at multiple subs if possible. Maybe 2 VTF-2 mk5s if possible? That would be a killer setup and potentially have a better room response than a single sub.

 

[Capt'n_Ron]

I would look at multiple subs if possible. Maybe 2 VTF-2 mk5s if possible? That would be a killer setup and potentially have a better room response than a single sub.

yes that would be an option, concerned about chuffing though. I had a single monoprice ported 12" sub and it was underwhelming in the space. I was considering stretching the budget for 2 vtf-3 mk5 hp for duals.

I will try that in the REW simulator for alternate options.

 

[shadyJ]

yes that would be an option, concerned about chuffing though. I had a single monoprice ported 12" sub and it was underwhelming in the space. I was considering stretching the budget for 2 vtf-3 mk5 hp for duals.

I will try that in the REW simulator for alternate options.

Two VTF-3 mk5s would be pretty insane. You would have a ton of headroom for sure.

 

[Capt'n_Ron]

I think I can get by with one sub for know. At least willing to try that first due to budgeting. the rew simulator did confirm that from 30hz down the response gets smoother with dual subs. dual subs would likely rule out any potential chuffing issue due to room gain.

 

[highfigh]

I think I can get by with one sub for know. At least willing to try that first due to budgeting. the rew simulator did confirm that from 30hz down the response gets smoother with dual subs. dual subs would likely rule out any potential chuffing issue due to room gain.

Don't place it at the middle of any wall.

Chuffing comes from excessive air velocity in the cabinet's vent/port, not room placement.

Or, it can be caused by everything exceeding expectations.

 

[Capt'n_Ron]

I thought bad room placement would require more gain, in essence trying to fix the problem with the volume knob.

REW says a rear corner placement is best for me. mid wall is a no go for me, says REW..

 

[William Lemmerhirt]

I thought bad room placement would require more gain, in essence trying to fix the problem with the volume knob.

REW says a rear corner placement is best for me. mid wall is a no go for me, says REW..

The problem is you can’t boost a null created by the room/placement. A null is basically a vacuum, and turning up the gain will increase output, but you won’t know it at the MLP. Everywhere else in the room and house will definitely get the extra output, and you’ll essentially use up all of your headroom and possibly destroy your sub/s.
Phase nulls, can usually be dealt with by using phase/delay/distance tweaks.