speaker wiring kinda like bi-wiring

CyboLynx

CyboLynx

Audioholic Intern
<font color='#000000'>ok ...here is my delema ...

this is what id like to do ...and id like all your advice about it if possable


i have a set of JBL CF-150's ...
i have a SONY STR-DE585 ...
and i have a QSC MX1500a ....


what i want to do it this ...
run the sub out on my amp to my poweramp ....
then disconnect my woofers on my speakers and run them to the power amp ....

then ...the mids and tweeters would be still connected to the speaker out on my sony ...but id run my sony in small mode for the speakers and direct all the bass to my power amp ...

just wanna know the pros and conns ....


this is the specs on my speakers ....
? Recommended Power Amplifier Range: 10 - 325 watts
? Nominal Impedance: 8 ohms
? Woofer: 15&quot; polymer laminate w/cast frame
? Midrange Driver: 6.5&quot; polymer laminate
? Tweeter: 1&quot; titanium laminate
? Frequency Response: 32Hz - 20kHz
? Crossover Frequency(ies): 850Hz - 4.5kHz
? Sensitivity: 98dB (1 watt/1 meter)

this is the specks on my amps sony ....
? 5.1 Multi-Channel Analog Input
? UniCommander® Remote Control
? 2 Component Video Inputs: HD Pass (80 MHz)
? Dolby® Digital, dts®, Dolby® Pro Logic® II Decoding &nbsp; &nbsp;
? 5 Channel Power Rating: 100W Per Channel x 5 (8 ohms 1 kHz, THD 0.7%)
? 2 Channel Power Rating: 100w Per Channel x2 (8 Ohms 20hz - 20khz THD .09%)
? Black Finish A/V Receiver
? 5 Channel Power Rating - 100 Watts Per Channel x 5 (8 ohms 1 kHz, THD 0.7%)
? Dolby® Digital, dts®, Dolby® Pro Logic® II Decoding
? 32-bit Dolby® Digital, Dolby® Pro Logic® and dts® decoder ? 32-bit DSP with 11 Acoustic Environments
? Digital Cinema Sound? System with Cinema Studio EX modes
? Subwoofer Pre-Out Level Impedance : - 2V/1 k ohm

now my poweramps specks....
STEREO MODE, Both Channels Driven....

FTC 8 ohms 20 Hz-20 kHz 0.01% THD - 350W
4 ohms 20 Hz-20 kHz 0.01% THD - 500W
EIA 8 ohms 1% THD - 400W
4 ohms 1 kHz 1% THD - 600W
2 ohms (typical) 1 kHz 1% THD - 750W

BRIDGE MONO MODE....

FTC 8 ohms 0.1% THD 20 Hz-20 kHz - 1000W
EIA 4 ohms (typical) 1 kHz 1% THD - 1500W
Frequency Response (20 Hz-20 kHz) - ±0.15 dB
Input Sensitivity @ 8 ohms - 1.05 Vrms
Voltage Gain - 50x (34 dB)
Cooling (rear to front airflow) - 2-Speed Fan
Normal Operation @ 4 ohms/ch (120 VAC) - Less than 10.5 A
Weight 42 lb (19.1 kg)

ALL MODELS.....

Distortion (SMPTE-IM) - Less than 0.05%
Damping Factor - Greater than 200
Dynamic Headroom - 3 dB at 4 ohms
Input Impedance - 10 k ohms unbalanced, 20 K ohms balanced

Input: 1/4&quot; TRS and Barrier strip
Speakers: Touch-proof binding posts

Amplifier Protection....
Full short circuit***, open circuit, ultrasonic, &amp; RF protection.
Stable into reactive or mismatched loads.
Load Protection On/off muting, DC-fault grounding relay with internal fault fuses.
Output Circuit Type - Complementary linear outputs: 2-Step Class H
Power Requirements - 100, 120, 230 VAC, 50-60 Hz

any help and stuff would be appreciated ....:) for i have sold my little sub woofer cause i dont like it ...

i allready have some nice cables for the sub out ...sheilded rca cables &nbsp;and i also have rca to tsr connectors ...there good quality ...not the best ...but they arnt cheap either ...goldplated and what not ...same with my bannana plugs on my speakers ....

iv also thought about bypassing the crossover with my mid and wiring it straight to the binding posts and only have the tweeter running to the crossover ...yet my amp will still be in small mode ....

anyhow please help here...i really wanna incorperate my power amp into my system ...and i cant afford to buy a sub or a new set of speakers ...just not affordable ....</font>
 
Last edited by a moderator:
CyboLynx

CyboLynx

Audioholic Intern
<font color='#000000'>anybody ?

ideas ....tips ..anything ...theorys ....</font>
 
G

Guest

Guest
<font color='#000000'>CyboLynx,

An active crossover is the ticket for bi/tri-amping.  If you run your tweeters full range, your woofers full range, etc., it isn't likely to work very well.

Hope this helps,

Chuck</font>
 
A

av_phile

Senior Audioholic
<font color='#000000'>Let me see if i understood your set-up correctly:

You want to bypass the crossover of your stereo speakers between the woofer and the mids and run the woofer directly to a power amp connected to the sub-out of your 5.1 receiver.

That seems ok, the receiver's sub-out is supposed to be cutover at or below 200 hz, and you would equivalently be using a powered sub connected to it. &nbsp;But does your receiver have L and R sub out? &nbsp;Otherwise, you'll be feeding each of your woofers with L + R low frequencies. &nbsp;Nothing worng with that, except that contrary to the notion that LF are non-directional, LF above 80Hz are. &nbsp;And you can confirm that as you can distinguish a stereo bass from a mono bass via headphones.

You want to set the 5.1 receiver to SMAL and run its speaker out directly to the speaker's mid and tweeters. &nbsp;And you would also want to bypass the mid's crossover. &nbsp;Nothing wrong with that. &nbsp;Hopefully the mids can handle the cutofff frequency of the receiver 's SMALL setting which usually starts at 200hz. &nbsp;Mids are typically cut-off at around 400Hz in speakers. &nbsp;But you can try. &nbsp;Are the mid drivers sealed at the back? If so, they may have difficulty pumping out below 400 Hz.

Just my 2 cents.</font>
 
CyboLynx

CyboLynx

Audioholic Intern
<font color='#000000'>ok ...i just ran into a pair of N24II ...

so now what im thinking is this ...

i run my JBL CF-80 as mains ...the N24II as my surrounds ...
NcenterII as center ...

then i could run my power amp from my sub out to my CF-50s and still bypass the crossovers and run straight to my woofer ....

how dose that sound ?? ....

i can still run my mains as large cause they rate at 45hz - 20khz ....

surrounds and center as small ...

now i dont wanna run my amp hard but i like bass ...but i also like the definition ....like the strings on the bass guitar being picked up as there slapped ....or picked ...

i also like to hear the glass shatter as its being broke and tingling on the floor ...and when the thunder hits i like to hear it ...

but i truely enjoy music as its best ....

oh well ...ill play with them all and find the best configuration...wish i had a nice sub ...lol

but im sure 2 15&quot; woofers with a poweramp can back that up ....for now ..lol


yeah i dont mind ripping my speakers appart ...to get the better speaker how can you with out experimenting eh ?

meh ...anyhow ...its fun even if i have to put everything back to its original way ..:)</font>
 
Last edited by a moderator:
newsletter

  • RBHsound.com
  • BlueJeansCable.com
  • SVS Sound Subwoofers
  • Experience the Martin Logan Montis
Top