Looking for Opinions on Setup using 4 Sealed Mach 5 FTW 21" Sub Woofers

[lovinthehd]

The only ported subs I have seen , were commercial, store bought ones and they sounded ok, but just not the sound I wanted. The issue I would run into using a ported box is I dont have the room for 4 ported refridgerator size boxs lol So I am just going to do sealed and see where this takes me.

Did you look at the SPL modelling graphs for the 4 subs I posted?

How does it look to you?


Its my first attempt at sub moddeling and, It seems like a tonne of output right from 10 HZ right up to my crossover at 80hz.

This will definitley have more output than my 2 paradigm x12's

Thought you just posted a single box sub with four drivers....how different from four boxes am not sure otoh. What do you plan to do for eq to flatten response?

 

[lovinthehd]

I have not modeled the room, but It sounds like I had better learn to figure that one out too lol

I do have REW on the laptop and was going to get a umik 1 microphone as I believe I need to use REW to setup the MINI DSP Flex HTx with it.

After that is setup, I will be using the ARC room correction on my Anthem reciever to dial the room in.

I will likely set it up the way I desrcibed first and see how it sounds before I play with it and start moving the subs around.

The room modeling is just a feature of REW, doesn't require a mic.

 

[lovinthehd]

The only ported subs I have seen , were commercial, store bought ones and they sounded ok, but just not the sound I wanted. The issue I would run into using a ported box is I dont have the room for 4 ported refridgerator size boxs lol So I am just going to do sealed and see where this takes me.

Did you look at the SPL modelling graphs for the 4 subs I posted?

How does it look to you?


Its my first attempt at sub moddeling and, It seems like a tonne of output right from 10 HZ right up to my crossover at 80hz.

This will definitley have more output than my 2 paradigm x12's

Not familiar with the Paradigm X12s in any case otoh