Audio Research amps

m. zillch

m. zillch

Enthusiast
Dr. Floyd Toole, a leading audio scientist and researcher, writes in part 3 of his book regarding their heat:

"Solid-state amplifiers typically have output impedances in the range 0.01 to 0.04 ohms (damping factors from 800 to 200). Tube amplifiers typically range from 0.7 to 3.3 ohms (damping factors from 11 to 2.4), and occasionally even more. These are large losses, and when placed in series with the frequency-dependent impedances of loudspeakers, they cause audible changes in spectrum; the loudspeakers have essentially been “revoiced” by the tube power amplifier. See Figures 16.1 and 16.2, pp. 434 and 436. Stereophile magazine measurements of power amplifiers include frequency responses when driving a simulated loudspeaker load. The deviations are sometimes substantial. Somehow this is not discussed in the subjective reviews, when what they are hearing is through loudspeakers that have been modified in ways they do not know. They are not the products the manufacturers designed.

As a general statement, it is advisable to leave tube/valve amplifiers to those who believe that their sound is as satisfyingly warm as the air above them.
"
 
TLS Guy

TLS Guy

Audioholic Jedi
I'm very cautious. C'mon, Doc, I figured that you would consider 'coffee warmer' as about the highest and best use of a tube amp!
Don't think I would go that far, but close. It is not that tube amps are bad. People my age used them with good results for years. However there are now better options, and our speaker infrastructure is not conducive to getting the best from tube amps. Altogether that makes them a less than ideal option.
 
newsletter

  • RBHsound.com
  • BlueJeansCable.com
  • SVS Sound Subwoofers
  • Experience the Martin Logan Montis
Top