Using unusual amp

  • Thread starter Thread starter Kingnoob
  • Start date Start date
Kingnoob

Kingnoob

Audioholic Ninja
Oct 4, 2019
3,048
0
38
North canton, Ohio
9120b1b1c11f016717d12898ca627c97.jpg

f5bc14459ab59ea3ec540aea566df0cc.jpg

e0dec63007287a3a8b8b8f31afb170c5.jpg

Works well but I need a new cable for radio [emoji343]... no idea how to ...wire speakers [emoji344]


Sent from my iPhone using Tapatalk
 
Do I need to rip my speakers apart for low or high freq or just use 4 speakers ??
How on earth do you do this


Sent from my iPhone using Tapatalk

You have to find the speakers they were designed for. That was an odd system in a box, that used active crossovers. Unless you have the speakers that came with that unit it is totally useless to you.

Again you have bumbled about, as is your usual modus operandi, and accumulated more junk you have no clue about. You seem to be on a one man mission to degrade this forum into the world's number one red neck forum.
 
Got me, what did the manual say?

I think the original speakers [emoji344] had bass and treble on separate channels.
Guess I can just mess around with it it’s a lot better then our garage radio [emoji343]....

I got plenty of speakers [emoji344] to mess with ... just not many good ones .. R.I.P.
giphy.gif


Sent from my iPhone using Tapatalk
 
I think the original speakers [emoji344] had bass and treble on separate channels.
Guess I can just mess around with it it’s a lot better then our garage radio [emoji343]....

I got plenty of speakers [emoji344] to mess with ... just not many good ones .. R.I.P.
giphy.gif


Sent from my iPhone using Tapatalk

As I told you, this device is no use to you. That unit has four power amplifiers, and an active electronic crossover. So the preamp stage goes to an active electronic crossover. The speakers that went with that unit were three way. The electronic crossover has low and high pass filters. The high pass signal was amplified by the HF amps connected to the mid range and tweeter in each speaker via a passive crossover in the speakers. This high pass signal was split into the band pass signal sent to the midrange and the high pass sent to the tweeter by the passive crossover in each speaker.

The low pass signal from the electronic crossover was sent to the bass amps and connected directly to the woofers

The electronic crossover also sent the correct power and frequency slopes to match the woofer and band pass drivers for an even power and frequency response in the crossover region.

That is why that unit is only any good with the matching speakers. If you want to use it you have to look for a set of those speakers. The impedance of the two speaker sections were both six ohms.
 
Why are you so intent on using this? Why do you think it's sooooo much better than your garage radio? Junk it or attach 4 of the same speakers and see what happens. Now you've got TLS wasting his time telling you things that you won't listen to.
 
This is more effort than I deserve to put into it, but...


The speakers are SS-EC70.


As with all your purchases, I hope you didn't spend much to get it. It's not worth investing any more money trying to polish a turd.

(you could always inquire here before buying anything... might save you a lot of money now and ridicule later.)
 
c3e19b9cb4e1037154c4efa5e1017163.jpg

d40a1b23bd8a8562d1ea96f8f67a7e09.jpg
very clear sound but bass is lacking I may try different bass modules or woofers .
Think [emoji848] the woofers aren’t the issue ?
There in mint condition.. barely used . Should I try different ones

Sent from my iPhone using Tapatalk
 
c3e19b9cb4e1037154c4efa5e1017163.jpg

d40a1b23bd8a8562d1ea96f8f67a7e09.jpg
very clear sound but bass is lacking I may try different bass modules or woofers .
Think [emoji848] the woofers aren’t the issue ?
There in mint condition.. barely used . Should I try different ones

Sent from my iPhone using Tapatalk

Look, unless the top and bottom speakers have exactly the same sensitivities as the speakers that system was designed for it will either lack bass or treble. The chance of you finding junk speakers with the same parameters as the original are one in a million or less.

I have to say all these pictures of your junk sure lower the tone round here. They are enough to give an old man a heart attack. May be look for somewhere else to hang your laundry?
 
The taco bell bag really adds to the overall ambience and aesthetic of your system. Lets a person know exactly what to expect in a noob setup. Does it sound as good as it looks tho..?
 
very clear sound but bass is lacking I may try different bass modules or woofers .
Think [emoji848] the woofers aren’t the issue ?
There in mint condition.. barely used . Should I try different ones
Yes, yes, indeed! Try many, many!
Dr. Mark seems confident that you will find the right one if you try enough (about a million).
It is a trial and error process, so you'd best get crackin'!
I am impressed by your steadfast commitment to find good audio using such monumental perseverance.
But you know, it wouldn't be the same if you don't devote a major portion of your life to your objective.
Like my dad used to say:
"When you're dumb, you've gotta be tough!"
 
  • Funny
Reactions: NINaudio and Pogre
newsletter

  • RBHsound.com
  • BlueJeansCable.com
  • SVS Sound Subwoofers
  • Experience the Martin Logan Montis