as far as the amp...how should the mode switches go
input 1
1) clip limiter ...on
2) low cut filter 50 hz or low cut filter 30 hz...30 hz
3) low cut filter...off
4) stereo/ parallel inputs...parallel inputs
5) stereo/ parallel inputs...parallel inputs
input 2
6) bridge mode...on
7) bridge mode...on
8) low cut filter...off
9) low cut filter 50 hz or low cut filter 30 hz...30 hz
10) clip limiter ...on
this is my best guess from reading the instructions.
it says not to turn off low cut filter, but i think a sub should go under 30 hz and the dcx2496 will handle this???
it says to use both positive outputs from both channels when bridged....does this mean i put the red speaker wire in the input 1 positive speaker output and the black speaker wire in the input 2 positive speaker output. is that it?
also the speaker says it handles 1000 watts...how's it going to handle 2400...or can it handle that amount of power for short periods of time
