Crown XLS 2502 for Buttkicker LFE ?

[rana_kirti]

Planning to setup Tactile for Home Theater.

Is the Crown XLS 2502 a good Amp for Buttkicker LFE ?

XLS2502 Manual says :

"The PureBand Crossover System provides a variable state Linkwitz-Riley 24dB/octave filter allowing you to choose a point between 30Hz and 3kHz on standard 1/12th octave centers. Three filter types are available: Low Pass, High Pass and Band Pass"

LFE Manual says :

"Frequency Response: 5 – 200 Hz"

So does this mean that the XLS2502 will not be able to utilize the ButtKicker LFE abilities below 30Hz ?

Thanks.

 

[everettT]

Planning to setup Tactile for Home Theater.

Is the Crown XLS 2502 a good Amp for Buttkicker LFE ?

XLS2502 Manual says :

"The PureBand Crossover System provides a variable state Linkwitz-Riley 24dB/octave filter allowing you to choose a point between 30Hz and 3kHz on standard 1/12th octave centers. Three filter types are available: Low Pass, High Pass and Band Pass"

LFE Manual says :

"Frequency Response: 5 – 200 Hz"

So does this mean that the XLS2502 will not be able to utilize the ButtKicker LFE abilities below 30Hz ?

Thanks.

If you don't apply filters it runs full range.

 

[dlaloum]

And the Crown specs are talking about setting crossover points - the central turnover point of the crossover...

So you can set the crossover to be a low pass filter at 30Hz - ie: to attenuate the frequencies ABOVE 30Hz - leaving the frequencies below intact., or it can be set as a 30Hz high pass filter with the opposite effect

It doesn't state that 30hz is a frequency limit!