Well, the manual is pretty useless in this regard. The specs give power ratings for bridged, but there is no information in the manual for the input and output requirements that are necessary for bridged use (check the manuals for amps from other brands to see what I mean). So proceed at your own risk. The descriptions/explanations given for Bridged, Stereo, and Dual Mono (more commonly called “Parallel”) modes are the most ridiculous I’ve ever seen.
That said, you’re really chasing your tail here. In your case here’s no reason to bridge the amp to begin with. The 1000 is rated for 2-ohm operation, so you can just run your two 2-ohm drivers directly from each amplifier channel directly.
I mean, think about it: Bridged, the amp delivers 1050 watts at 4-ohms. Connect your two 2-ohm speakers, wired in series for a 4-ohm load, and that 1050 watts is divided between them: 525 watts to each. Run the amp in stereo, and connect a 2-ohm speaker to each channel and you have 530 watts to each speaker. IOW, it’s a wash, except that the former scheme is a hassle and the latter is easy and straightforward.
Get it?
Regards,
Wayne A. Pflughaupt