I purchased a XMC-2 and a couple of XPA amps to replace my Denon 4400H a few months ago. I installed a four post rack to hold move everything into.
I hooked everything up, and the projector (Sony es285) made a click and died. (No power) Sent it back to Sony and they replaced the main board and shipped it back.
While waiting on the Sony, I've used a 50" LG TV, with no issues.
I got the projector back. Re-Mounted it, powered it on, ran the test grid and then started to connect the HDMI cable (Which run though the wall and used it with the Denon/es285 for 3 years prior) I hear a click and down went the projector again.
I've got a few ideas and next steps but would like to hear other thoughts.
TIA
My Current 7.2.4 System
Main speakers:
Klipsch RP-280F FLOORSTANDING SPEAKERS
Center:
Klipsch RP-440C
Side Surrounds:
Klipsch RP 250S
Back Surrounds:
Klipsch Reference Premiere RP-600M
Subwoofers(2):
SVS PB-3000 - SW (Left & Right front)
Height channels (4):
SVS - Prime Elevation (Ceiling mounted)
Prepro:
Emotiva XMC-2 Manual
Amps:
Emotiva BYO XPA- seven-0 gen3 &
XPA-5 Gen 3
Build Your Own (Custom Configuration) Audiophile Power Amplifier seven-7-0
Projector:
Sony VPL-VW285es
Screen:
Screen Innovations 7 Series Fixed - Black Diamond Fixed Frame Screen 120"
Power Conditioner/Surge protection:
Panamax 5300-PM Power conditioner
Sources:
Panasonic UB820 Blu-Ray Player,
Sony UPB-x700 Blu-ray player (For SACDs), Xbox one, Playstation 4, Roku Ultra, FireTV 4K(For Tidal Atmos), Sega Genesis and a Chromecast Ultra.
Front Row seating:
SeatCraft Vienna Multimedia Sofa w/
SoundShakers
Side Seating:
SeatCraft Vienna Multimedia Loveseat w/
SoundShakers
2nd Row seating:
Seatcraft Monterey Back Row of 3 Loveseat right w/
SoundShakers
Room Dimensions: 28’ x 13’
Layout in Floorplanner
Uses: Movies Blu-rays, UHD Dolby Atmos/Streaming (60%), Music Tidal/SACDs (20%), sporting events (10%) and Video Games (10%)