For those of you following this thread and are not sure of the difference between the input sensitivity on the amp
I spoke with Crown and I had a question about what the difference was between the two input sensitivity settings on the XLS1502...
He said:
**************************************************************************************
At .775V it will be louder.
Input sensitivity is the amount of voltage RMS it takes to drive the amplifier to peak output, so the lower the number the quicker it gets louder.
The .775V setting is for cases where the output of the device sending the signal to the amplifier doesn’t have anymore headroom, the disadvantage of this is it’s more noisy than the higher setting.
It’s safe as long as you don’t overdrive the input and clip the amp. - Crown
*************************************************************************************
