Denon AVR3311 help

[Cygnus]

I just hooked up my new Denon, and have the following issue.

I want the Playstation to output audio over HDMI, and to output video over composite. I have the composite connection hooked up to the "BD" input on the receiver, and the HDMI hooked up to HDMI-1. The output from the receiver to the TV is over component video.

When I change the input assignment for the PS3 to HDMI, I lose the video. I'm assuming this is because of the priority that the Denon has with video inputs (HDMI, Component, then Composite.) Can I change that, or am I buggered? If I hook up the PS3 with a component cable, will that work?

 

[GlocksRock]

I think if you hook up HDMI that will take priority for the video, if you want your video to be composite or component, then I think you will need to hook your audio up via toslink.

 

[Cygnus]

Thata what i ended up doing, so i pretty much have to get a new tv now. Not a big deal though; i was planning on it anyways.

 

[Cygnus]

Also, I have an issue where my 64GB iPod touch 3rd gen shows up fine when I connect it, but whenever I try to play something, it buffers the song, but the song never starts - it just sits there, and the buffer occasionally changes from 100% to 90%, 80% 100% etc... Also, I'm assuming the artist and track etc. are supposed to show up on the TV GUI but doesn't. Just says "Now Playing".

 

[Cygnus]

Anyone? My ipod does have the latest software on it, though I haven't done any firmware updates on the Denon as it's difficult to do so with my current networking, and Internet configuration.

 

[tonedeaf]

You might want to post over at AVS forum.There is a specific forum for your model.
A gentleman named batpig is the resident denon genius over there and will probably point you in the right direction.

 

[Cygnus]

You might want to post over at AVS forum.There is a specific forum for your model.
A gentleman named batpig is the resident denon genius over there and will probably point you in the right direction.

Thanks for the tip. I posted over there, and apparently it's not a fault of the AVR's, but with the new iOS software for the ipods.

 

[edoggrc51]

Using my iphone4 running the lastest FW, the Denon and phone communicate just fine. Zero problems. Perhaps a FW update might help?? Good luck, hope you get the problem sorted out.