Been messing with a wonderful problem. I’ve got a new pair of SX-T2 speakers in my environment. There are so many ways to configure.
I do a lot of two channel, and desired to have a full 16hz-22khz for stereo. I have two SA-400 amps driving the bases. I have my receivers high level output going into the SA, through the 100 Hz filter that runs the upper towers, then out to the subs.
I’ve configured my receiver to a 5.0 system, and so far it seems to scratch my itch for low end. I’ve also mused over allowing the uppers to run full signal, then set a 50hz crossover and set the sub bases as dedicated subs, but I would loose my full stereo low end.
I had a very powerful pro amp powering the bases, but the low end was so weak I could never strike a balance between the upper tower and the subs. I’ve ordered a device that will allow for higher voltage to pass in to the amp, but the SA-400 amps seem to be more than adequate.
Im just looking at what folks are doing out there. Thx