first off here is my set up Audio:
Onkyo :tx-sr805
Polk: rti8's
Polk: rti4's
Polk: fxi3's
Polk: csi'3
Velodyne: VRP 1200 (12inch) soon to be a SVS sub
RTI8 specs:
Mid/Woofer 2 - 6-1/2" Diameter (16.51cm)
Polymer Composite Dynamic Balance Cones with Rubber Surrounds
Tweeter 1 - 1" Diameter (2.54cm)
Silk/Polymer composite dome
Electrical
Overall Frequency Response 30Hz-27kHz
Lower -3dB Limit 40Hz
Upper -3dB Limit 26kHz
Nominal Impedance 8 ohms
Recommended Amplifier Power 20-250 w/channel
Efficiency 90 dB
Crossover 2.2kHz, 12dB/Oct Low Pass, 18dB/Octave High Pass
Inputs Dual (bi-amp) gold plated 5-way binding posts
1.Should i get a two channel amp to run the RTI8's and save the rest of the power for the other 5 speakers?
2. Should i get a two channel amp to bi-amp the fronts (not sure which to bi-amp the tweeter or 6 1/2's)
3. Leave my system alone because i have a bad case of upgradicus (A.K.A. upgrading)