Hello Friends,
i am about to throw a very silly question here that confuses me alot and it is about Subwoofer Setup particularly the cross over settings..
i have PSB Subsonic i-6 subwoofer and Denon AVR x4400h. now during my Audussy setup, AVR guides me to roll out subwoofer cross over to the maximum position and there it sets the subwoofer through test noises with speakers. Now the confusion is that Audioholics and some other you tube channels, it states to set your sub cross over point approx 10db higher than the minimum cross over frequency of our speakers. since i have Jamo c809 floor stand speaker, its minimum frequency is 30hz.
1 - Should i be tweaking cross over point at subwoofer plate after audussy is done?
2 - In Denon AVR, It also has the subwoofer cross over point that one can set accordingly. should be using that tool also ?
3 - while sitting at my sweat spot and test tone on through AVR, i changed the phase switch from 0 to 180 and back to 0 (with help of my friend) and i didnt feel any difference in base. Is there any issue in my setup ??
hope to have your assistance onto these three questions