killdozzer
Audioholic Samurai
SOME GOOD NEWS, FINALLY!!
It worked for half the problem. Here's the update step by step:
This is a docking I made to prevent cone touching a hard surface. This way It was suspended in air 1/3 of an inch above the working table.
The driver is suppose to go into the middle square, obviously, thus:
Only then did I start unscrewing the screws and by the smart advice from @Swerd, I color coded the connections:
It is hardly visible, but there's a blue mark inside the red circle in the pic.
It worked for half the problem. Here's the update step by step:
This is a docking I made to prevent cone touching a hard surface. This way It was suspended in air 1/3 of an inch above the working table.
The driver is suppose to go into the middle square, obviously, thus:
Only then did I start unscrewing the screws and by the smart advice from @Swerd, I color coded the connections:
It is hardly visible, but there's a blue mark inside the red circle in the pic.