ToddMorrill
Audioholic Intern
Sounds good, I am sold, is there another driver that you prefer to the dayton near the pricepoint?
And do I need high pass / low pass filters? I dont see them in the build you posted above below is the part list from that thread. Going to start ordering stuff tomorrow. I need to mail order everything to my buddy to bring via plane to me down here (besides the mdf), so lmk if there are some non obvious small things to make my life easier.
Driver 249.75
Binding post plate 10.90
Binding post 18.47
1" MDF 5 sheets required for a pair. You would probably need 3 sheets for a single without rearranging the cut layout. 64.00/sheet
Wood glue 20.00
PL 20.00
epoxy 5.00
socket cap screws 6.00
threaded inserts 8.00
paint 18.00
bondo 8.00
MDF screws 12.00
Rockboard 60 or 80 30.00
And do I need high pass / low pass filters? I dont see them in the build you posted above below is the part list from that thread. Going to start ordering stuff tomorrow. I need to mail order everything to my buddy to bring via plane to me down here (besides the mdf), so lmk if there are some non obvious small things to make my life easier.
Driver 249.75
Binding post plate 10.90
Binding post 18.47
1" MDF 5 sheets required for a pair. You would probably need 3 sheets for a single without rearranging the cut layout. 64.00/sheet
Wood glue 20.00
PL 20.00
epoxy 5.00
socket cap screws 6.00
threaded inserts 8.00
paint 18.00
bondo 8.00
MDF screws 12.00
Rockboard 60 or 80 30.00