Crown NXLS1500-0-US Power Amplifier
I'm new to all of this ..thanks.
No bi-wiring..and does my sub need to hooked pto the Crown? being that my sub already has an amp??
No you do not connect a powered sub to the Crown. As I said before you connect the sub to an LFE output on your Yamaha receiver.
You should have told us which Crown amp you were using. I can't mind read you or snoop on your set up.
Your amp has built in electronic crossovers which you should not be using.
I can bet you had the amp set to low pass mode, and now you have one channel set to high pass and one to low pass.
It is all on page 4 of the manual. Now read it before you make any further posts. You have wasted a lot of your time and ours already.
1. Hold the “Mode/Menu” button down for 3 sec until the LCD screen displays
“Amp Mode <More>”.
2. Press the “Mode/Menu” button to begin confi guring the Amp Mode.
3. Press the “Next” button until the LCD screen displays “Input Y”. Now press the “Mode/Menu” button to confi rm.
4. Now press the “Next” button until the LCD screen displays “XOVER” and press the “Mode/Menu” button to confi rm.
5. Now use the “Previous” or “Next” button to select your desired crossover point.
6. Once you have selected your crossover point, press the “Mode/Menu” button to confi rm your selection. The LCD screen should
now read “Input Y XOVER”.
Obviously you should not be in any of those modes.
This is the mode you need to be in.
XLS Series
Power Amplifi ers
Operation Manual
page 4
Stereo Bypass Mode
This is the default mode the amplifi er is set to from the factory. The amplifi er is
confi gured for stereo mode with the PureBand™ Crossover System Bypassed.
1. Connect Left/Right signal source to Channel 1 and Channel 2 using either
the XLR, ¼ Inch, or RCA connectors.
2. Connect a speaker to each channel output using Speakon
®
, Banana Plugs,
So presumably you scroll through the menu once you get into it until you see Stereo Bypass mode and select it.
One other thing make sure your amp in not in bridge mode.