TxRz 3100 what is the volt on the preouts am pairing it to monolith 7 amp

[Paul s]

What is the volts on the presets on the txrz3100 onkyo pairing with monolith 7 amp

 

[TLS Guy]

What is the volts on the presets on the txrz3100 onkyo pairing with monolith 7 amp

1.0 V/330 Ohms (Pre Out) 1.0 V/330 Ohms (Subwoofer Pre Out) 200 mV/1.2 k-ohms (Zone Out) 2.0 V/1.2 k-ohms (Zone Pre Out)

The monolith requires 1.6 volts for full output.

However that is only a 2db mismatch and insignificant.

 

[Paul s]

1.0 V/330 Ohms (Pre Out) 1.0 V/330 Ohms (Subwoofer Pre Out) 200 mV/1.2 k-ohms (Zone Out) 2.0 V/1.2 k-ohms (Zone Pre Out)

The monolith requires 1.6 volts for full output.

However that is only a 2db mismatch and insignificant.

? I know the Manuel says that has anyone tested it rz 70 says same but tested at 4 v

 

[TLS Guy]

? I know the Manuel says that has anyone tested it rz 70 says same but tested at 4 v

I don't know if anybody has. In general I can tell you that AVRs in general have low and poor overload margins. I would doubt you can get 4 volts out of that AVRs preouts.

I have no clue why you are asking the question, or what you are concerned about. You are really parsimonious with your information, which makes intelligent replies impossible and makes you a very irritating poster.