Heights Should be Wider?

  • Thread starter Thread starter Squishman
  • Start date Start date
Squishman

Squishman

Audioholic Samurai
Jul 1, 2017
2,526
0
38
66
This is my bedroom system and these L&R fronts are the Ascend ones that need 2 of four new woofers. This is where I am positioning them. So now, are my heights too narrow by about a foot? They are toed in. Would it help to point them straight out and of course re-calibrate, which I will do again when new woofers arrive. I haven't ordered them yet, but I will. It's a 5.2.2.
 

Attachments

  • FB_IMG_1736382145376.jpg
    FB_IMG_1736382145376.jpg
    21.4 KB · Views: 226
This is my bedroom system and these L&R fronts are the Ascend ones that need 2 of four new woofers. This is where I am positioning them. So now, are my heights too narrow by about a foot? They are toed in. Would it help to point them straight out and of course re-calibrate, which I will do again when new woofers arrive. I haven't ordered them yet, but I will. It's a 5.2.2.

That is way off Dolby Specs. Thos speakers should be on the ceiling half way between you and the end of the room.
 
That is way off Dolby Specs. Thos speakers should be on the ceiling half way between you and the end of the room.
Ok. As wide as the mains then?
 
I would maybe not toe them in since they are in the front of the room. If you are going to, I would flip the speaker vertically so the tweeter is on the bottom.
 
I would maybe not toe them in since they are in the front of the room. If you are going to, I would flip the speaker vertically so the tweeter is on the bottom.
Flip them if I leave them there or even if I move them where TLS Guy says they should go?
 
Here you go. Correct placement is this. Ignore everyone else that says otherwise.
@TLS Guy you seem to be blindly guessing I'm afraid.
 

Attachments

  • 5.1.2 atmos.jpg
    5.1.2 atmos.jpg
    33.7 KB · Views: 173
  • Dolby atmos spacing.jpg
    Dolby atmos spacing.jpg
    447.4 KB · Views: 174
Flip them if I leave them there or even if I move them where TLS Guy says they should go?

If they are at the exact same height, flip them for this location.

Ideally, you want this, so this is what you are trying to simulate (5.1.2):

5_1_2_spkrplc.jpg


 
Last edited:

Latest posts

newsletter

  • RBHsound.com
  • BlueJeansCable.com
  • SVS Sound Subwoofers
  • Experience the Martin Logan Montis