HDMI Splitter 2x2 with eARC

[randomuser]

Hello All,

I am seeking some advice on how I can avoid buying another AVR in the master bedroom but use the same AVR that I already use for the living room. So, I am looking for an HDMI splitter, that has eARC capabilities, which can receive signal from 2 sources and send them to 2 different displays? I will not be using the 2 displays simultaneously but one at a time. My AVR is set up with Apple TV, Shield and other media streaming devices, I should be able to use the same devices in both rooms.

Any idea, if there is a solution available in the market that I can use, rather buying another AVR?

If not, I would like to just get a cheap AVR / AV Processor that has preouts for adding addition power amps to provide some extra power to the speakers, I will be using KEF Q750 in the master bedroom, with a SVS SB3000 sub woofer, I am yet to add the surround and center speakers....

Appreciate you inputs... Srisha

 

[Eppie]

I went on to Amazon and searched for HDMI splitter 2 in 2 out and found these. I would not recommend this, though. These devices have not been tested by forum members so I don't know if they work as advertised. You asked for eARC support and none of them mention eARC or even ARC support. They claim HDCP support but switch boxes can cause HDCP and CEC issues as they require two way communication. HDMI splitters are best when no ARC or CEC control is required (and eARC requires CEC to be enabled).

I would opt for a separate AVR in the bed room. AV processors are expensive, so you can get an AVR for the same money and use the internal amps for the surrounds and center. The KEF Q750 has a rated sensitivity of 88dB which is pretty good, so you may not need that much power in a bedroom unless it is a large room. An AVR with 100W per channel would likely do the job. If you want pre-amp outputs for external amps, that moves you into a higher cost category. I believe the first Denon to offer full pre-outs is the X3800H. That's a good AVR with 105W per channel and should drive the KEFs fine unless you are after theatre level volume. Onkyo RZ30 might be less expensive in your area but service and support might be a concern. I think the Yamaha A4A is the first model to offer full pre-outs.