M
moreira85
Audioholic Chief
Bedroom set up I have a Hisense TV, Amazon fire cube, and Yamaha rx a770.
if I watch with Hisense setting in hdmi 2.0 normal mode everything works appropriate W no issues.
When I change the Hisense to Enhanced HDMI mode I get “weak or signal“ on the screen with no picture. in order to get the picture back I have to toggle the setting back to normal hdmi 2.0 On the tv.
Now if I unplug the TV from the wall outlet and plug it back in to reset it the TV then I am now able to select Enhanced hdmi format and it works with a nice enhanced video output. So all is good now right?
THE ISSUE IS WHEN I AM DONE WATCHING TV AND POWER ALL THE DEVICES OFF and come back a few hours later and power them back on it says “weak or no signal” And I have to go back to hdmi 2.0 standard mode in the tv to get a picture again.
ANY THOUGHTS ON THIS?
The picture is much better in enhanced and I’m trying to figure this bug out.
I have a similar set up in the basement w a Hisense TV also but don’t have this issue with it.
if I watch with Hisense setting in hdmi 2.0 normal mode everything works appropriate W no issues.
When I change the Hisense to Enhanced HDMI mode I get “weak or signal“ on the screen with no picture. in order to get the picture back I have to toggle the setting back to normal hdmi 2.0 On the tv.
Now if I unplug the TV from the wall outlet and plug it back in to reset it the TV then I am now able to select Enhanced hdmi format and it works with a nice enhanced video output. So all is good now right?
THE ISSUE IS WHEN I AM DONE WATCHING TV AND POWER ALL THE DEVICES OFF and come back a few hours later and power them back on it says “weak or no signal” And I have to go back to hdmi 2.0 standard mode in the tv to get a picture again.
ANY THOUGHTS ON THIS?
The picture is much better in enhanced and I’m trying to figure this bug out.
I have a similar set up in the basement w a Hisense TV also but don’t have this issue with it.