Feedback Destroyer 1124p help needed

[mikey d]

Hey guys,

Im starting to wonder if my device is defective, maybe one of you can point out something obvious im missing.

1. I set input level in bypass with the in/out light blinking.
2 set in/out button to lit
3. jog dial to preset 10. 1-10 available
4. set filter mode to PA and coupled R and L
5. pressed filter select and set filter 1 to pa, freq 60hz, bandwidth 10, gain -10 and press store twice
6. repeated this process for filter 2 and 4.
7. set preset jog to 10, horizontal leds show that 1, 2 and 4 are lit.

I run a pass with REW and there are no changes.

Im stumped guys.

 

[WaynePflughaupt]

A common “gotcha” – does the little indicator just to the right of the numeric display say “kHz?” If so, you made your adjustment at 6,000 Hz, not 60.

Regards,
Wayne A. Pflughaupt

 

[mikey d]

i double checked to be sure just now and its hz for sure

 

[mikey d]

looks like the left channel is bad.

seems like I bought a junker. the right channel i can make changes and see them by they rarely correspond with the changes I dialed in.

 

[highfigh]

looks like the left channel is bad.

seems like I bought a junker. the right channel i can make changes and see them by they rarely correspond with the changes I dialed in.

Are you using any kind of Y cord for the two channels, for any reason?