Do you guys leave your receivers on 24/7?

P

PKS17

Enthusiast
I used to leave my older amp on 24/7. I never really turned it off ever, and didnt have any problems. But i just bought a brand new amp, and dont want to take any chances.
Do you guys leave your receivers running all night, or do you turn it off when not in use?
 
Adam

Adam

Audioholic Jedi
I turn mine off whenever I'm not using it. It uses electricity and gets hot when it's on, so I don't keep it powered up.
 
MinusTheBear

MinusTheBear

Audioholic Ninja
When I am done using my receiver I always turn it "off" in which it goes into standby.
 
mike c

mike c

Audioholic Warlord
IMO, any new receiver should be turned off when not in use. they give off too much heat even when idle.
 
Hi Ho

Hi Ho

Audioholic Samurai
Why leave it on? A receiver draws quite a bit of current at idle. That is made obviouse by the amount of heat that is output. Heat, over time, is electronics death nell.

I see absolutely no reason to leave a reciever on 24/7. It serves no purpose, may shorten life, and adds to ones electric bill.
 
dorokusai

dorokusai

Full Audioholic
I keep mine in standy-by and have never noticed a heat issue.

Mark
 
Adam

Adam

Audioholic Jedi
I should update what I said - I also have mine in standby, which I consider to be off.
 
MidnightSensi

MidnightSensi

Audioholic Samurai
My pre-processor and amplifier I tend to shut off, but, if my voltage regulators/power units are right it doesn't make much of a difference between when they idle and when they are off.

In my little studio, I leave my active monitors on all the time, they don't even have a power switch. At idle they don't consume much according to my power conditioner and the manufacturer, so, I just leave them on.

So, basically, I doubt it makes much of a dent in your power bill, but if your receiver gets hot then shut it off.
 
Hi Ho

Hi Ho

Audioholic Samurai
I also meant standby when I said "off". I assumed that most people consider standby to be off as it is as close to "off" as most modern components get without pulling the plug or physicially switching a master power switch (like many receivers have) which renders remote power on moot.
 
P

PKS17

Enthusiast
Ok, so i guess im just lazy, But from now on, it will be in standby mode when not in use
 
3db

3db

Audioholic Slumlord
I think my receiver is in standby mode when I power "main off" There's another button, master on/off for all the zones.
 
GlocksRock

GlocksRock

Audioholic Spartan
No, I just leave mine in standby, my computers are the only equipment I leave on 24/7
 
Midcow2

Midcow2

Banned
Standby is "off"

I should update what I said - I also have mine in standby, which I consider to be off.
Standby is "off". The light if any, is usually an LED or lovw voltage nenon type bulb which indicates wall power.

My son was playing Xbox 360 "Mortal Combat' on the media room system and the "old" Def Techs (fronts- 2006 and sub prosub100) really make you jump when the punches are hard.
 
lsiberian

lsiberian

Audioholic Overlord
I'm cheap so I have mine in a power strip and turn the strip off when I'm done. After of course I put it in standby.

I also wear a jacket around my apartment instead of cranking the heat up. So that tells you how cheap I am lol.
 
Phil Taylor

Phil Taylor

Senior Audioholic
I put mine in standby cause when I turn off the source - like my Blu-ray player for instance - the display blinks constantly which indicates no input and it bothers me ... much like the flashing "12:00" on VCRs without the time being set used to. ;)

BTW - back when I was a video engineer we left everything on 24/7 as heat cycling does degrade the life of components somewhat - due to expansion and contraction of solder joints. But the heating issue was handled with COLD air conditioning ducts to component racks - if you've ever been in a broadcast facility you'd understand. I used to wear a jacket at work year-round.
 
phlakvest

phlakvest

Audioholic
BTW - back when I was a video engineer we left everything on 24/7 as heat cycling does degrade the life of components somewhat - due to expansion and contraction of solder joints. But the heating issue was handled with COLD air conditioning ducts to component racks - if you've ever been in a broadcast facility you'd understand. I used to wear a jacket at work year-round.
I know that feeling. Last show I helped out on we had a broadcast trailer instead of a portable "fly" pack. The 30 feet surrounding the trailer was 10 degrees warmer than the rest of the arena.

Back on topic. I leave mine off when I'm not using it. (which is basically when I am at work or asleep.)
 
Pyrrho

Pyrrho

Audioholic Ninja
I'm cheap so I have mine in a power strip and turn the strip off when I'm done. After of course I put it in standby.

I also wear a jacket around my apartment instead of cranking the heat up. So that tells you how cheap I am lol.
Instead of "cheap", you might describe yourself as environmentally responsible. You are using less power, and therefore are causing less pollution than if you cranked up the heat in your home and left things on all of the time.

Also, this leaves you with more money for other things. You could describe yourself as frugal or thrifty, or not wasteful.

When I think of someone being "cheap", I think about things like what is happening when someone goes to a restaurant and stiffs the waitress by not leaving a tip (in a country, like the U.S., where tips are expected; obviously, in countries where waitstaff are paid a livable wage without tips would be different). Or going to lunch with several people who order salads, while one eats lobster, and then suggesting that everyone just split the bill evenly. In other words, someone is "cheap" when they don't pay for something for which they should be paying.


To answer the initial question, I shut things off when I am not using them. It isn't so much the bill for the power, as the thought that I do not want to be responsible for another coal plant being built (or whatever other nasty thing would be done).

So, lsiberian, I think you are doing something too noble to be called "cheap". Even if it is only the money that is motivating you. After all, it isn't like saving this money is hurting others. It would be different if you were hurting others for money, but as it is, you are doing good for others for money. And there is nothing wrong with that.
 
newsletter

  • RBHsound.com
  • BlueJeansCable.com
  • SVS Sound Subwoofers
  • Experience the Martin Logan Montis
Top