Denon AVR X3700H initial setup advice

[Tony Cardenas]

Oh wow - this is fantastic - thank you very much for sending it. For sure takes the guess work out of it. Many thanks!

 

[lovinthehd]

As far as what the settings for crossover are, if it were up to Audyssey it would start them off at 80hz when using a sub. Experiment.

Try these

Changing the cross-over settings after running Audyssey

I am a little bit confused on how Audyssey works. I looked at a lot of the posts, but I could not find the exact answer I was looking for. I just got my new Onkyo TX-NR808 and ran the setup last ni...

audyssey.zendesk.com

Crossover points selected by Audyssey setup

Hi, My setup is KEF 3005 SE + Denon AVR-1610. I have done the auto calibration about 5 times (each with six measurements) and Audyssey keeps setting the crossover for the front and surround speake...

audyssey.zendesk.com

 

[Tony Cardenas]

As far as what the settings for crossover are, if it were up to Audyssey it would start them off at 80hz when using a sub. Experiment.

Try these

Changing the cross-over settings after running Audyssey

I am a little bit confused on how Audyssey works. I looked at a lot of the posts, but I could not find the exact answer I was looking for. I just got my new Onkyo TX-NR808 and ran the setup last ni...

audyssey.zendesk.com

Crossover points selected by Audyssey setup

Hi, My setup is KEF 3005 SE + Denon AVR-1610. I have done the auto calibration about 5 times (each with six measurements) and Audyssey keeps setting the crossover for the front and surround speake...

audyssey.zendesk.com

Thank you so much. I read this now several times that '80Hz' seems to be a good starting point when using a sub. I think I'll experiment and move it up a bit for everything. I wish I had the budget right now to upgrade the sub. I never really took into consideration how increasing size/output would impact things (with an 8in now)