Audessy XT32 Not Hearing A Speaker

[Mike Green9]

Hi.

I set up my Denon AVR-X3800h as a 5.1.4. Great AVR - all 9 speakers and sub make for an awesome listening experience.

In order to improve my setup, I purchased the Audessy XT32 phone app. It connected with the Denon, and sent a request to the SUB to start rumbling, allowing me to adjust the volume. Worked great.

Then the App had the Denon send a tone from the Front Left Tower. I could hear it clearly. However, the App said it could not. I re-tryed several times to no avail. I cancelled the App and started it again with the same results.

I know all my speaks are working just fine. I know the Denon mic is connected properly as it heard the Sub. The App requests a tone from the Font Left Tower that I can clearly hear, but it can't.

So what gives ?

Thanks,
M...

 

[TLS Guy]

Hi.

I set up my Denon AVR-X3800h as a 5.1.4. Great AVR - all 9 speakers and sub make for an awesome listening experience.

In order to improve my setup, I purchased the Audessy XT32 phone app. It connected with the Denon, and sent a request to the SUB to start rumbling, allowing me to adjust the volume. Worked great.

Then the App had the Denon send a tone from the Front Left Tower. I could hear it clearly. However, the App said it could not. I re-tryed several times to no avail. I cancelled the App and started it again with the same results.

I know all my speaks are working just fine. I know the Denon mic is connected properly as it heard the Sub. The App requests a tone from the Font Left Tower that I can clearly hear, but it can't.

So what gives ?

Thanks,
M...

I don't understand why you are using a phone app. So use the Denon to do the calibration. If that works then you downloaded bad software to your phone.

 

[lovinthehd]

Which app are you using? The Audyssey MultEQ Editor app? You're using it to run the microphone/setup routine rather than doing that in the avr (and then manipulating with the app)?

 

[OCA]

Try with this tool: