Search results

I would say with 90% confidence it probably does.

The problem is with XLR and ONLY the main L/R channels.

I'm still using the 5100. The only gripe I have about it is the slow HDMI switching. 5200 distortion issue is mostly a bench test problem though admittedly I have not connected it to my system to test for audibility. If you pick an amp that reaches full power at 2Vrms it will probably be fine...

Hollywood is doing itself no favors going Woke. If you need any example, just check out the trash shows on the CW now. I remember when Arrow used to be watchable. Can't wait for Batwoman. LMAO.

I did a little YouTube video about this topic for those that don't wish to read or just want another perspective:

Umm interesting, if NOT stupid observation. Were my "Biases" affected when I called out Sound United for misleading power ratings on their AVR's since the advent of overspecing Atmos receivers came about, or when I wrote this article...

The dedicated prepros from Marantz have plenty of drive for your amp. Never switch from a current Prepro to an AVR to use as a Prepro.

I doubt the AVM60 is a fully differential design from input to output especially since their STR is NOT. The Anthem engineer I spoke to prefers converting to single ended between stages as you can see in my review...

Ah I misunderstood and yes agreed.

Be careful comparing manufacturer spec sheets. The output voltage you're quoting from Marantz is NOT a max rating. Their receivers can do 4Vrms unclipped so you can bet their preamps can as well. The AVM60 is NOT an upgrade in terms of analog preamp compared to the Marantz.

That's no typo, I lifted all 132+lbs of the POA-A1HDCI up 2 flights of steps and loaded it into my AV rack by myself. I didn't walk right for 2 days after.... I sold it as a package deal with my AVP processor unfortunately. Yes ATI is a great option for sure. Benchmark is a bit pompous. They...

Actual in theory, doubling the voltage would increase power 4X. However, that never happens due to power supply limitations. The MX-A5200, as well as other bridgeable amplifiers I've measured, typically switch to a lower voltage tap of the transformer when in bridged mode to prevent this. This...

Yea the top sections of the RBH speakers are an easy load for a good AVR to power. The bass sections need a good meaty amp though.

Most bridgeable amplifiers come with a warning like this. Remember, each amp now sees half the load impedance that it would in a single amp connection. I think this is mostly done as a precaution and probably to still maintain heat dissipation requirements for UL. I hit the 5200 into 4 ohm loads...

I would NOT use any of the amplifiers you mention in this most to power the bass sections of the RBH T system. That would be way too taxing on the power supply and a dedicated amp offers far better control and dynamics. I tried using the Denon POA-A1HDCI amplifier in bridged mode to power my...

You basically want the $7500 Denon POA-A1HDCI for 1/3rd the price. Definitely not going to happen.

Where did you get max power ratings for the Yamaha amps? I don't see that on their owners manual. The MX-A5200 is likely based on the amp design of an RX-Z11 not the 3080. Also, NEVER use the low setting on the impedance switch...

I'd agree the Monoprice ATI 11CH clone is a step up from the MX-A5200 but there are no other 11CH amps on the market to consider. I would still take the 5200 over the GEn3 XPA-11 Emotiva amp from what I've seen. NAD doesn't make 11CH amps.

SNR is pretty good for both modes. I'm talking about distortion and how it's impacted based on bridged vs unbridged.

Correct but the 5000 amp wasn't bridgeable either.