2 multi sub setup help?

[Kingnoob]

I have one sub a jamo I just moved Infront of the room. And a klh in the back both are 10”. Using a Onkyo TX-NR818, these two are replaced my bigger sub that so far I’ve been forced to keep upstairs. I’ve gotten a xt32 trim of -15 all but my last try was -14. But I had to raise it to -9-10. After eq. Had to switch each sub around to opposite loc

get -9.5 trim running a single sub , -14 or -15 running two.

Any tips the klh still sounds louder the then jamo. So I’ll have to run it again at Some point. Not sure if I can get it to -10 after running audysee.

 

[Matt34]

It would be ideal to level match the subs to 75db (one at a time, using pink noise) at the MLP before running your room correction. If I remember correctly (and going off your screenshots) the 818 doesn't have sub eq ht, so it's treating both of them as one.

 

[Kingnoob]

It would be ideal to level match the subs to 75db (one at a time, using pink noise) at the MLP before running your room correction. If I remember correctly (and going off your screenshots) the 818 doesn't have sub eq ht, so it's treating both of them as one.

K the klh seems to be boomy in a corner but my only other spot to try is the mid room wall. I cannot fit both Infront of the room. Once again too afraid to ask about getting a better sub so I’ll have to wait til one of these break. Because bestbuy doesn’t carry them here or have them on sale . So I can’t just go buy one and switch it out for the klh. And it might end up just as boomy even with a better model. If it’s room nodes .
Besides it would be an mis match one better sub with a Cheap one.