Help pioneer 503 elite reciever work with monolith 7 or outlaw 7000

P

Paul s

Enthusiast
Have pioneer vsx503 elite reciever will the outlaw 7000 or monolith 7 work well with it main channels have 1 volt on preouts
 
P

PENG

Audioholic Slumlord
So maybe didnt buy well still not sure by that if the receiver has enough volts on preouts to fully get all the power out of either amp
ASR also measured the 503, it has high enough voltage to drive a typical 400 W amp to its rated output but like the 504, they didn't perform very well aside from distortions.
 
P

PENG

Audioholic Slumlord
To see how poorly it measured, just pay a visit to ASR.

Note that the poor results do not mean the unit would necessarily sound bad compared to those measured much better, but it may, under the right conditions.
 
lovinthehd

lovinthehd

Audioholic Jedi
So maybe didnt buy well still not sure by that if the receiver has enough volts on preouts to fully get all the power out of either amp
That was more to show it can likely exceed the nominal 1V rating you mentioned. Monolith 7 is out of stock until July, too and also has 1.6V sensitivity vs the 7000X's 1.2V. Why a 7ch amp?
 
newsletter

  • RBHsound.com
  • BlueJeansCable.com
  • SVS Sound Subwoofers
  • Experience the Martin Logan Montis
Top