Faulty internal crossover?

[lovinthehd]

Can't do that quite yet. I've only been using one measurement point while getting the hang of REW and the miniDSP. Now I need to take several more points and get a good response across the MLP. Sounds great when I sit in the middle of the couch (where the mic was placed), but I am getting some localization of the sub when I shift to the left (closer to the sub located on the front wall to the lower left of the mains). Sitting to the right sounds pretty good.

I'm guessing after taking several measurements I keep the best of the set, average all of them, then apply my filters?

FYI, I've been taking three points for Audyssey while experimenting, but will be taking 6 next go around (can't take measurements behind the MLP because it is up against the wall).

Can't the MLP be moved away from the wall first?

 

[mossman77]

Can't the MLP be moved away from the wall first?

Nope. Otherwise the couch would block the dining room and foyer.

 

[mossman77]

How much improvement do you guys think it would make if I lowered the left and right channels down lower to either side of the fireplace as opposed to up high on the left/right of the TV? The center of the speakers (tweeter) are currently at about 70", whereas ear level is about 42". Lowering them down would put the tweeters lower than ear level though (because they are LCRs). I'd probably need a different speaker for that to work (one with the tweeter offset to the top).