Hi guys,
I recently upgraded to an RX-V2600, and have been really happy with it! When I first got it, I ran the auto setup, and everything worked just fine. However, I just moved things around a little (well, moved all the theater equipment and ended up putting it back in more or less the same place), and wanted to run the auto setup again. This time, it gets through the "pre-check" phase just fine, but during the "main check" it does one of two things:
-It starts the main check, but really, really loud. The receiver then shuts itself off, possibly an overload?
-It runs the main check, but does not actually produce the noise.
I didn't want to tinker with it too much for fear of damaging a speaker. Any ideas what could be wrong? Any help would be greatly appreciated!
Thanks much,
-Mike
