Svs Pb 10 Isd

[mulester7]

......comments, please....JGarcia, I noticed you have one....please comment on how the sub responds being cut on the top higher than 80, if you have tried that.....

 

[j_garcia]

This thing has fairly flat response across it's range. Has no problem operating with a 100hz x-over, actually, I could almost not tell the difference. Have not tried it higher than that though. How high are you thinking possibly?

 

[mulester7]

This thing has fairly flat response across it's range. Has no problem operating with a 100hz x-over, actually, I could almost not tell the difference. Have not tried it higher than that though. How high are you thinking possibly?

.....not sure how high I want them cut on top, JGarcia....am considering two sorta' in the middle, off the floor, sitting on "open" 2x4 skeletal stands, about two feet off the floor, firing forward....and, am considering their being cut from about 50 down on the low end....I am envisioning/considering them, as small cannons, for upper sub range, for possible imaging/point, "de-nutted" on the very low-lows, by either a Paradigm X-20/30, or a Behringer 2496 series unit....

 

[j_garcia]

So what are you using for the LOW lows? Nuttin? Or something serious? Might be a question you'd want to ask SVS directly, the're pretty good about answering questions. (two minutes is not long enough though).

 

[mulester7]

So what are you using for the LOW lows? Nuttin? Or something serious? Might be a question you'd want to ask SVS directly, the're pretty good about answering questions. (two minutes is not long enough though).

.....JGarcia, I am employing two used boxes in the front corners for the low-lows, and they do a decent job....

.....I'm looking forward to cannon experimentation again, and will probably not have to seek emergency room care during this one, haha.....that 1000 watt 18 was wicked......

 

[mulester7]

.....no tellin' where Buck and Mac are....I think Buck was driving with Mac navigating, so they may have turned wrong leaving Seattle.....

 

[Buckeyefan 1]

.....no tellin' where Buck and Mac are....I think Buck was driving with Mac navigating, so they may have turned wrong leaving Seattle.....

We'll have an update for everyone next week when we're back home. We spent approx. 2-3 hours there today and demo'd EVERYTHING THOROUGHLY. Got in 18 holes at nearby Mahoning Country Club soon afterwards. Have a great weekend.