RXV2400 problem....

[ned]

After calibrating and setting up the level, I notice that it will revert back to the auto setup level. I've repeated the calibration several times and it keeps happening. Any ideas? Solution? Thanks.

 

[Marco]

ooops

Are you doing a auto set up? and then it goes on??? Or is it a Manual set up?

 

[Unregistered]

Are you doing a auto set up? and then it goes on??? Or is it a Manual set up?

Manual set up.

 

[jzac]

Well, I think you have the option to either save or exit at the end of the manual calibration...if I recall correctly. Make sure you are saving your manual setup settings. It should work.

 

[LeadTrac]

After you go through the calibration and set up again, go through the menu until you come to the memory guard option. Activate memory guard and that should solve your problem.

I hope this helps