Hi everyone!
I bought a Silver 3805 and after a lot of problems with supply, I have a black 3805 "loaner".
I'm trying to program the RC-969 to turn on the receiver, cable box and TV with one system call macro. I've typed them up and programmed them but they don't work, something is wrong, I was wondering if some one could look at them and tell me where I went wrong, I'll make the corrections and post them here as payforward, so others can program their remotes as well
Here goes:
====================================================
Programming the Denon RC-969 Remote
(Set preset codes)
Cable box
Off On
“1” (For “preset memory” )
“Cable” (Mode button for component you want to set)
“Enter”
0503 (“Preset Code” for Motorola)
“OK” flashes
Television
Off On
1 (For “preset memory” )
“TV” (Mode button for component you want to set)
“Enter”
1127 (“Preset Code” for Sony TV)
“OK” flashes
(Set up “System Call” Macro to turn everything ON)
Off On
3 (For system call settings)
Amp (Turn on the Amp)
Enter
Source On
Cable (Turn on the cable box)
Source On
TV (Turn on the TV)
Source on
Enter
“Call” 1
OK Flashes
(Set up “System Call” Macro to turn everything OFF)
Off On
3 (For system call settings)
TV (Turn off the TV)
Enter
Source Off
Cable (Turn off the cable box)
Source Off
Amp (Turn off the Amp)
Source off
Enter
“Call” 2
OK Flashes
===================================================
My problem may be with selecting Amp in the "turn it all on" section.
With everything off, do I have to press "On" first on the remote THEN run the macro? or can I just click system call then 1 to turn it ALL on?
Gonna go wire the rear speaker...
Thanks in advance
Fred
