I am new here and would like some advice and help making a decision,I have 2 subwoofers I built with boston 10" drivers in a daul 10" enclosure.I have no information on the drivers other than they are 6 ohm and measure in at 5.2 ohms.instead of doing a passive crossover I want to get a amp with crossover biult in like the Inuke series from behringer.my question is can I do both subwoofers with the inuke 1000dsp,I know it has bi amp capabilities wich I will use later to drive a sub and a BIC fh6 lcr speaker.oh and the sub is 2 ohms wired in parrelel,one of the main reasons for looking at this type of amp.the plate amps dont do below 4 ohms.
but for now I want to use the inuke for the 2 subs.Can I use the inuke to drive both subs using channel 1 and 2 as a low pass channel?I have looked at the manual and I think I can But If I could get some verification and clarification on how to do it I would appreciate it.Inuke seems the best choice for this for the price I am willing to pay(200-300) I will also take recomendations on other simular amps in that range I see Crown,QSC and others but have not studied as I have the Inuke.Thank You,Cleon
