power amp for subs

[cleonjr]

ok I need a power amp for some subs I made they have 2 10" drivers in each one there are 2 of them the drivers are 6 ohms each but measure 5.2 so in series thats 10 oms or in parelel 2.5 ohms.I think the 2 ohms would be better suited since there are amps that will do that load.

I have been looking at the berhinger line of amps,the Inukes .I like the features of the built in crossovers,that way I can also run the satelites with the amps also.these Are the 2 I have narrowed it down to
http://www.behringer.com/assets/NU60...00DSP_M_EN.pdf I think the nu1000dsp would be enough power but i could go to the 3000,the qsc amps look good too can I get some advice .

 

[jinjuku]

The amps you are looking at will have fan noise. You would have to be willing to mod them for use if they are installed the listening room.

Yesterday I modded my iNuke 3000DSP with:

Amazon.com: ENZOTECH Memory Ramsink BMR-C1 (Forged Copper Heatsink): Computers & Accessories

and

http://www.amazon.com/Noctua-NF-R8-80mm-Fan-CFM/dp/B000S95RWE/ref=sr_1_2?s=pc&ie=UTF8&qid=1395415709&sr=1-2&keywords=80+mm+quiet+fan

This requires some soldering. I can't hear any mechanical noise from the Behringer but you can feel air being forced out the front.