I have done the Dirac measurements on the laptop.
When I transfer filter curves to the Onkyo, it overwrites edited crossover settings with the original values used during measurement setup.
Annoying. Can anyone please confirm this behavior?
The way speaker level info is stored and shown is not always clear.
From the web interface (ciuser/ciuser) you find save/recall to/from receiver (EEPROM) or file.
When you change levels via the remote, the state is not immediately displayed on the web interface -> reload page
When you change levels via level test noise via the web interface, it is not retained (or I am missing something).
What are your findings?
If the picture is clear, I would file a ticket with Onkyo.
