help with nu3000dsp

[240jz]

Hello, I just received my Behringer nu3000dsp and I'm going to be using it to power my JLW6 sub. Here is the problem I have the amp hooked up in bridge mode and I'm using a B&K RECEIVER. I cannot seem to adjust the amp to get enough sound out. I read somewhere and they said it would be ok to run it the way I have it set-up. Do I need some sort of level booster? Thanks

 

[jinjuku]

If you need a converter you will get the Art CleanBox Pro.

With my Denon I need one to run both my Behringer 3000DSP and my old EP2500 but not my XLS 402D.

 

[240jz]

Is this the only way to make it work? Thx

 

[lucasamiller]

Same problem here, the Art Cleanbox Pro fixed it. It also allows you to convert RCA to balanced (XLR).

Make sure if you get one, turn down the gain and level on your amp. First time I hooked up the Art Box, my sub receiver was at +10 and it knocked picture frames off the wall.

 

[240jz]

Alrighty then I will order one asap... Thx for the help

 

[240jz]

I received the clean pro and hooked it up. Any help with setting up the amp for maximum SQ/power. Right now it sounds weak for being a 3000rms amp.