Ep4000 to harman/kardon avr 3700

[Lonetexan05]

Very frustrated why is there no bass ... At all... Whatsoever

 

[crossedover]

A picture is worth a thousand words, well in this case not. Can you explain what's going on and what your trying to do. Adjust your speaker size settings probably

 

[Lonetexan05]

The speakers are doing nothing bass is all the way up on the home theatre amp
Looks to me like its getting input but no output

 

[Lonetexan05]

Two 8 inch pro box subs wired in series if that matters

 

[crossedover]

What are the speaker settings on the hk? set mains to small. If no sound still switch from sub preouput to main preouts with the volume down to check the beheringer.

 

[Lonetexan05]

Was thinkin it was the settings too but its getting signal... Idk the thing is pretty confusing

 

[j_garcia]

Is the amp being run in bridged mode? Looks like you have the speaker wires connected to both positives.

 

[Lonetexan05]

Thats how everyone says bridged mode woks the two middle ones even though they are red one is marked negative

 

[j_garcia]

What does the manual say about bridged mode? Usually you have to switch something else to put it in bridged mode for it to work. The wires do look to be correctly connected though. Try running one channel or the other with it setup the way it is now and see if you get sound, then check what else needs to be configured to give you bridged.

 

[Lonetexan05]

Fixed

So i finally sat down tonight and patiently went through everything and. I knew it would be something simple the negative wire was lose at the speaker
this is the part where we all say WHat a NOOOOB!!! Yea.. Blonde moment whatever its fixed thanks for trying fellas