Denon AVR - 1707 ( Auto Set up )

[dickw]

I have the Denon AVR - 1707 and have run the Auto- set up, but I can't
figure out how to *see* what auto setup did ( such as large vs small, xover, distance etc ).

How can I display that information. I must say the Denon manual is either
not very user friendly or it may be my lack of knowledge.


All this is very new to me ( first time owner of AV gear ). I have learned a lot from this forum ( maybe to much for my own good ), but I can't apply any of that knowledge until I know what the auto set up did.

Thanks.
****

ps. I have the following gear...

Mirage Omnisat V2 FS for front right and left
Mirage Omnisat CC
Mirage Omnisat S-8 sub.
no rears
Panny S-52 DVD
Sony 50E2000 TV

 

[AVRat]

You probably need to get into the advanced setup menus - pg. 45.

 

[tomd51]

I don't have a 1707 to verify, but you should be able to navigate through the settings via the display on the front of the receiver. On pg. 11 of the manual, it states you should be able to check the results, then store them.

Or as AVrat pointed out above, you may want to look at the 'Advance Settings' section of the manual... -TD