Connecting Polk PSW10 to Micca PB42x Desktop Speakers

[Nate Heidne]

Hello everyone, I am trying to figure out how to connect by micca's to my sub.

As of right now, I just have the Micca's connected with a 3.5mm jack to my PC. I tried using the line in RCA on the subwoofer and connecting that to the micca rca input but nothing.

Would I be able to use this preamp

and just daisy chain RCA cables ? Looking for the cheapest method for this, not looking to buy a receiver and center and all that. Please help. Very new to this.

 

[WaynePflughaupt]

Split the Pyle’s outputs with RCA splitters, and send one side to the sub and one to the Miccas. There will be no low-pass filtering for the Miccas. You’ll have to adjust the subs crossover frequency to blend with the Miccas by ear or measurement.

Regards,
Wayne A. Pflughaupt

 

[Nate Heidne]

The Micca's have a frequency response of 60Hz, so set the low pass to say 70Hz?

 

[markw]

The Micca's have a frequency response of 60Hz, so set the low pass to say 70Hz?

That's a good place to start, although a bit low, IM?NSHO.

Play with it for a while. It's not a hard and fast rule. Go with what works best for you.