Brand new to quality hifi

[Just4theah]

My plan is to tune my room around my new Canton Le207s I've acquired. I have 3 huge rolls of the acoustic material to make panels. I have the whole upstairs to myself. It's a 1.5 story home so I have the half walls and slanted ceilings with about 3.5ft flat ceiling. The room is 14ft wide x 22ft long then a doorway to the other side. Need amp ideas? Crown 25002 xls?

 

[lovinthehd]

The XLS2502 is a good power amp, but what will you use it with? What acoustic material did you buy?

 

[Just4theah]

Is the 2502 at low volume to much for the canton le207s? I have a bunch of rock wool to make panels

 

[lovinthehd]

Is the 2502 at low volume to much for the canton le207s? I have a bunch of rock wool to make panels

Not sure why you're thinking this way about amp/speaker match. At low volume the amp only is going to be putting out a couple watts, a very easy load for the amplifier. Keep in mind that they are power amps and you'd normally control the volume and source switching with a separate pre-amp or avr; the gain controls on the amp can be used as volume controls but not really the best way to go.

That you're going to treat the room with absorptive panels is a good start. Where are you placing them?