Hello again everyone. Gene this is for you. Thank you for everything you do
I recently read a post that you run 10AWG CABLE with your jumpers removed
And 10AWG JUMPERS in place. I know BI-wiring is no good, however iv done
So to get rid of the jumpers and instead of making my own jumpers I just bi-wired
With two runs of tributaries 12awg cable. Note. I liked that sound over special
Bi-wiring cable from Tributaries . I will not buy special bi-wire cable. My question
Was, you said you preferred 10awg cable with 10awg jumpers over a 12awg
Bi-wired config why ? My runs are only 5ft. Both are extremely low resistance
