Auto Setup

[hchytd]

Hi again fellas,

Before doing the YPAO auto setup on my yamaha receiver, where do I set my phase, crossover, and Level on my subwoofer. THen, after it does the auto setup, where do I put my phase, crossoever and level on sub.

PS I have an aperion audio 5.1 speaker setup and Yamaha RX-V2500.

Thanx in advance!

-Tiffany

 

[ParadigmDawg]

Hi again fellas,

Before doing the YPAO auto setup on my yamaha receiver, where do I set my phase, crossover, and Level on my subwoofer. THen, after it does the auto setup, where do I put my phase, crossoever and level on sub.

PS I have an aperion audio 5.1 speaker setup and Yamaha RX-V2500.

Thanx in advance!

-Tiffany

Start out with the crossover disabled or as high as you can set it, leave the phase at 0 and put the level about 1/3 to 1/2 of full gain. After auto set-up, go in and manually change the speakers to small and set the crossover to 80hz. Take a listen after following this and then we can get deeper into if you want.

 

[moreira85]

read this tread, read the bottom of the first page and the second page. zumbo does a nice job of walking through the yammy setup.

http://forums.audioholics.com/forums/showthread.php?t=36880