Multi-speaker selectors

[spyke]

Besides my living room setup, I have 6 pair of in-ceiling Paradigm speakers installed in my house (patio, garage, hallway, master bedroom, etc.). I'm looking for a good speaker selector switch to safely distribute the signal. My receiver is a Yamaha RX2095.

Each of the rooms have independent volume controls, so just push on/off buttons on the device is fine. Any recommendations?

Thanks,
Mike

[av_phile]

You need some form of multi-speaker distribution system.  Perhaps this site might interest you:

http://www.21best.com/21_best...._1.html

[Mudcat]

I noticed that all of the speaker selectors had either european multipin connections or spring clips.  Try a Tivoli (from Tweeter) or a Jamo.  Each has five way binding posts.  Each has impedance corrections/balancing so that you can listen to multiple pairs of speakers at the same time.