Search results

To successfully reset these receivers you need to start with the unit in the Standby Mode. To put the unit in the standby mode simply press the standby button when the unit is On or unplug the power cord from 120V AC and then plug it back in. Once in Standby Mode, press and hold down the STANDBY...

Not made by ATI. Jeff

There are lot's of ways to skin a cat. While amplifiers themselves do not compress before clipping, some amplifiers are designed with built-in clip limiters. Done properly, these amps use a very sophisticated peak detection circuit. When output peaks are detected, an input level compressor...

I use the R-972 daily in a family situation. I have Dish DVR, HTPC and Panasonic BD player all connected. The only issue is that audio comes up 5 seconds after the video when using any skip functions on the DVR and you occasionally lose 5 seconds of audio between tv program and commercial if...

I have never seen this problem with any R-972. Please check the settings on your blu-ray player. It should be set to bit-stream. Also, I had a "similar" problem with Monster's U this past weekend. The movie played in 2 channel. I finally discovered that Sony's easy play system optimized...

I do. I am Sr. Vice President of Amplifier Technologies. Jeff

RichB: ATI is not in a spec war with anyone. We design using the best value/highest performance components available that satisfy our design goals. Component pricing and availability are fluid. So are we. Jeff

I have not seen Rich's data. The usual cause of the transformer hum Rich has reported is DC on the AC line. The other interesting point is the lack of hum and noise when bypassing the Marantz and using the Oppo. If you follow standard trouble-shooting guidelines, that would rule out the ATI...

No comment. Jeff

I've been gone from Sherwood for over 2 years and do not know which subwoofer target they load into the R-972. Eugene Chavez, Sherwood's tech guru, should be able to answer the question and have the target curves. His telephone is (714) 739-2000. If he doesn't have the curves, please send me...

I use stereo with 3D remapping. Have you tried Delay and level, only? Jeff

If Trinnov does not display azimuth and elevation for every speaker, attempts to remap are unsuccessful and the image will be centered on the left front speaker. The good news is that the EQ does still work and the EQ, itself, is very effective. As I have written on other forums, there are...

ATI does NOT make amplifiers for Earthquake. Jeff

From my memory, the P-300 dates to 1975 when Teac was distributing Accuphase in the US. Great equipment in general. I owned the preamp and the tuner but did not purchase the amplifier as it had a tendency to shut-off driving 4 ohm loads. Jeff

Rolyasm: As all of the operating parameters are stored by input, making a comparison with Trinnov on/off is relatively easy. Assuming that your input is HDMI 1, set Video 1 to get it's program material from HDMI 1, engage the Trinnov settings you want, turn Trinnov to on and save the...

The end caps were actually developed for the titanium units (A-965, P-965, R-965). IMHO they look great on those units. And great on the black units, also. As to the pricing, as the guy who sourced them, $99.00 retail is a steal. Jeff

There is an SAE user's group on Yahoo that would be able to answer your questions. Jeff