Search results

  1. T

    Multi Channel stereo

    The reset without the thumb drive did the trick. I thought about it but got lazy. Funny thing is, I was on the phone with customer service for an hour with 4 put on holds for 5 minutes while the clueless tech went to ask for help. All he did was read the troubleshooting tips from the manual...
  2. T

    Multi Channel stereo

    Have a Denon avr x6500h that stopped playing through the front heights and side heights when in multi channel stereo mode. Speakers are active though in other modes like dts and dolby. Tried the unplug method and factory reset method using the thumb drive and it's still the same. Running a 9:1...
  3. T

    Mic Placement

    My man cave is my master bedroom. I am the only one using it so I only have one listening position to calibrate. Would it be better to be stingy and calibrate, say in an 8" box or spread out the 8 mic placements? TIA
  4. T

    slde surrounds and heights

    Thanks for the reply. There will only be two feet of difference. One side at 6 feet and one side at 8 feet.
  5. T

    slde surrounds and heights

    Okay to not be equidistant between side surrounds and height speakers? Room config won't allow. Will audessey take care of that?Thanks in advance.
  6. T

    Test tones

    Nothing, now that I stopped level matching after running Audeyssey. :) Just a tad embarrassed that it took me so long to find the article.
  7. T

    Test tones

    I do not change the distances. I use a tape measure to make sure my three main speakers are the exact same distance from the mic. Audyssey gets the L and R exact and the center just a bit further. I was doing both Audyssey and level matching because of a few you tube videos I watched.
  8. T

    Test tones

    I was running Audessey, then using an SPL meter with the test tone function to set each speaker which Audessey says you should not do.
  9. T

    Test tones

    Why do receivers have test tones available when Audessey recommends not to run test tones using a meter after running Audessey. They say the pink noise is not analyzed by Audessey filters thereby defeating the purpose of using Audessey.
  10. T

    Which brand makes the best quality loudspeakers?

    I have the same speakers and modded the front three with 3/8" of peel and seal and 2 to 4 inches of board insulation. They sound excellent and the center speaker sounds crystal clear. It's not an easy task, very time consuming but the end result is terrific.
  11. T

    What's the best receiver with 4k & audyssey capabilities for $1000 or less?

    You might want to consider the Onkyo 818. Tons of features great audio,great video upscaling. They may have finally got one right. They replaced my 807 barbecue grill with the 818. Good luck.
  12. T

    Onkyo TX-NR818 Manual Now Available (May 23, 2012)

    I just received this model as a replacement for my 807. I was pleasantly suprised as I was expecting an 809. Just fired it up for the first time and it sounds terrific. Lots of bells and whistles,I need to peruse the manual and do some tinkering. I hope they finally addressed the hdmi issues...
  13. T

    Cost of entry for XT32

    Lots of grumbling going on over at AVS forum. Seems EE took way more orders than they can possibly fill. I happen to be one of them.:(
  14. T

    surrounds

    Hello,I would use search function but its not working as of now. Recently ordered a 4311 by Denon and dowloaded the manual.(Did Denon hire professor Irwin Corey to translate the manual?) In speaker setup,the surrounds and heights are shown to be angled in and down towards the listening...
  15. T

    Which brand makes the best quality loudspeakers?

    You have a typo there although the people of Polish persuasion would take that as a compliment.:D:D
  16. T

    Production

    Th dealer is electronic expo. I've never dealt with them before. I've read where some folks suspected newegg of the same thing. They can repackage them to look brand new very easily.
  17. T

    Production

    Hello everyone,I have a quick question. Are the denon 4311-ci's still in production? I called an electronics dealer over the weekend and he stated that they had the unit on backorder. I want to go with this dealer because the price is ridiculously low,but I would question it as being a closed...
  18. T

    Tech help

    Thanks for all your help,I went with a wireless lynksys-e series. Set up was a breeze,works like a charm. More importantly though,it got my son and wife off my back:D
  19. T

    Tech help

    For all you tech savvy persons(I am not):(,here is my quandry. I currently run a wired router for my receiver,ps3,and computer. I chose this set-up for its reliability. We recently purchased an I-pad 2 for my son which needs a wireless connection to access wi-fi. Is there anyway I can run...
  • RBHsound.com
  • BlueJeansCable.com
  • SVS Sound Subwoofers
  • Experience the Martin Logan Montis
Top