Search results

I don't have a way to test the cable and no I live alone.

Def not there the whole time it is very noticeable, and yes I it is there regardless if it is a test pattern or not. Yes there is single small cable that goes from the box to the tv that does hdmi & power, I was impressed by the size of the cable especially it being 6 years old now, not so...

I have had this TV for about 5 to 6 years now has been wall mounted in the same spot the entire time, I recently noticed this mark which looks like something hit it but I live alone and I can't figure out what could of hit it. Any chance it could be the fancy cable which does hdmi & power? see...

I guess I could boost another freq on the input side if needed

I did it on the output not sure how much gain to start with thank you for the reply

I know its been a while but recently got everything hooked up, does anyone know how to boost at 50hz using the dcx 2496

I am using Dayton binding posts & plate combo links below, do I need to seal around the plate or the back side of the binding posts? If yes is clear silicone the best to use? Dayton Audio BPP-G Premium Binding Pos...

I finally made the cut on the back of the box, i still need to cutout a square patch for the inside to mount the plate to its just floating in there now. I wanted to ask if the backside of the plate should be sealed off, like a small box and just drill a small hole for the wire to run into the...

yes that certainly would have been easier but no regrets with the extra work i have created..

Dam wanted to get this but it is $130

I need to check again, im not ready to screw it down yet. I did a test run at making the cutout for the plate in the back, only issue is the corners are a bit large i believe because the radius of the bit i used was too large. Not even sure if its worth buying another bit to get it perfect, i...

does this gap seem normal its not screwed down ?

I plan to router the cutout this week. Next i need to figure out how to recess/mount those binding posts, i dont want them to stick out so much

This one shows why that one cut i talked about earlier had to be accurate.

i will post a pic once i figure out how to reduce the file size

i finally got the front cut to size to replace the messed up one, i plan to use the MDF Ring that ships with the sub along with a flush trim router bit for the cutout.

im embarrassed to say it but its not complete, but i will be starting up again tomorrow. i paid a local place to cut the circle in one of the front pieces, but it honestly looks like they cut it with a steak knife and i cant use the piece. So now i have to cut a new piece & the circle which...

any input on good binding posts for this application i came across the ones linked below i was thinking i could just drill a hole for each through the back but reading more about them it sounds like a plate is also required, not sure if it is 100% needed. I was not sure if the typical speaker...

I added some measurements to the photo, if needed I thought i could get a piece of 3/4" mdf and cut off the four corners and curve the inside using a jig saw and place one in each corner. Each one would fit between the two existing braces in the middle of each panel, i tried to show this with...